Materials and Reagents

D-glucose
NaNO₃
KCl
MgSO₄^.7H₂O
KH₂PO₄
ZnSO₄^.7H₂O
H₃BO₃
MnCl₂^.4H₂O
FeSO₄^.7H₂O
CoCl₂^.5H₂O
CuSO₄^.5H₂O
(NH₄)₆Mo₇O₂₄^.4H₂O
EDTA
Spermine
Spermidine
PMSF
Sorbitol
Halt Protease Inhibitor Cocktail (Thermo Fisher Scientific, catalog number: PI-78437 )
NaCl
KCl
Tris base
Glycine
Methanol
Bio-Rad protein assay (Bio-Rad Laboratories, catalog number: 500-0006 )
Miracloth (Calbiochem, catalog number: 475855 )
Rabbit polyclonal antibody to histone H4 acetyl K5 (1:2,500) (Abcam, catalog number: ab51997 )
Rabbit polyclonal antibody to histone H4 acetyl K8 (1:2,500) (Abcam, catalog number: ab15823 )
Rabbit polyclonal antibody to human C-terminus histone H4 antibody (1:2,500) (Abcam, catalog number: ab10158 )
Mouse monoclonal antibody to TATA Binding Protein (TBP) (1:1,000) (Abcam, catalog number: ab61411 )
Mouse monoclonal antibody to pan acetyl H4 (1:1,000) (Active Motif, catalog number: 39925 )
Goat anti-mouse alkaline phosphatase conjugated antibody (1:5,000) (Life Technologies, Gibco^®, catalog number: 13864-012 )
Goat anti-rabbit alkaline phosphatase conjugated antibody (1:5,000) (Pierce Antibodies, catalog number: 31342 )
1-Step NBT/BCIP (Thermo Fisher Scientific, catalog number: 34042 )
Glucose Minimal Medium (GMM) (see Recipes)
2x Laemmli buffer (see Recipes)
Nuclear Isolation buffer (see Recipes)
Resuspension buffer (see Recipes)
ST buffer (see Recipes)
TBS-T (see Recipes)
Western transfer buffer (see Recipes)
Media Recipes (see Recipes)

Equipment

Mortar and pestle
Bio-Rad Mini-Protean gel electrophoresis system (Bio-Rad Laboratories, catalog number: 170-3940 )
Semi-Dry Blotter (Bio-Rad Laboratories, catalog number: 170-3940)
Orbital shaker
15 ml Falcon tubes
50 ml Falcon tubes
30 ml centrifuge tubes
Microfuge tubes

Procedure

Nuclear extract:
Note: All nuclear isolation steps and solutions should be kept on ice.
1. Inoculate 250 ml of liquid glucose minimal medium (GMM) to a final concentration of 1 x 10⁶ spores/ml and incubate at 37 °C, 250 rpm for 48 h.
2. Collect mycelia by vacuum filtration through two layers of miracloth. Remove excess moisture by squeezing in between paper towels.
3. Place mycelia into a 15 ml Falcon tube and flash freeze in liquid nitrogen. After freezing, grind mycelia to a fine powder with a mortar and pestle under liquid nitrogen.
4. Transfer ~5 g ground mycelia to 50 ml Falcon tubes.
5. Add 40 ml of ice cold Nuclear Isolation buffer and vortex to mix.
6. Centrifuge for 10 min at 1,000 x g, 4 °C. Filter supernatant through a double layer of miracloth into 30 ml centrifuge tubes.
7. Centrifuge for 10,000 x g for 15 min, 4 °C.
8. Discard supernatant and resuspend pellet in 10 ml of ice cold Resuspension buffer.
9. Centrifuge for 10,000 x g for 15 min, 4 °C.
10. Discard supernatant and resuspend pellet in 1 ml of ice-cold ST buffer.
11. Transfer suspension into 1.5 ml centrifuge tube and pellet debris by centrifugation at 4,000 x g for 30 sec, room temperature.
12. Transfer supernatant into a sterile 1.5 ml centrifuge tube. Store at -20 °C if desired.
13. Quantify protein levels using Bio-Rad Protein Assay or equivalent.
Western blotting:
1. Load standardized amount of protein per sample (e.g. 50 μg) onto an SDS-PAGE gel with appropriate sample loading buffer (such as Laemmli 2x sample buffer).
  1. I used 10% Tricine-SDS-PAGE, cast according to Schägger (2006), and the Bio-Rad Mini Protean gel electrophoresis system.
2. Transfer to nitrocellulose membrane by electroblotting using the Bio-Rad Semi-Dry Blotter (can be done at room temperature).
  1. Soak your gel in western transfer buffer for 30 min and soak the nitrocellulose membrane in western transfer buffer for 10 min before blotting.
  2. Soak extra thick blotting paper in western transfer buffer–construct the “sandwich” according to the semi-dry transfer manual. From the bottom (+ pole) working to the top (- pole): Extra thick blotting paper, nitrocellulose membrane, acrylamide gel, extra thick blotting paper.
  3. Assemble apparatus and run at 15 V for 1 h.
3. Block membranes for 1 h at room temperature on an orbital shaker using 5% nonfat dry milk in TBS-T.
4. Incubate with primary antibodies for 1 h in TBS-T. 10 ml is sufficient for a small blot. Incubation may also be performed at 4 °C, especially if planning to reuse primary antibody solutions.
5. Pour off the primary antibody solutions. Primary antibody solutions may be reused up to 5 times, although antibody concentration will decrease with each use. (note: These solutions contain sodium azide as preservative).
6. Wash 3 x 10 min in TBS-T. Apply secondary antibodies in TBS-T for 1 h at room temperature. 10 ml is sufficient for a small blot.
7. Pour off secondary antibody solution (no need to retain). Wash blots 3 x 10 min in TBS-T at room temperature on the orbital shaker.
8. Add One-step NBP/BCIP developing solution and agitate gently. Keep an eye on the signal intensity, it will only be a matter of minutes to develop and development time will be different for each antibody. When reaches desired intensity (or just before), pour off the developing solution and rinse in several changes of distilled water. Incubate in ddH₂O for ~20 min.
  (Note: NBP/BCIP developer results precipitation of a colored substance on the membrane, thus, membranes cannot be stripped and reprobed. If intending to reprobe the membrane, alternative secondary antibodies (e.g. HRP or fluorescent conjugated) should be used.)
9. Blots can be dried on bench to preserve. Signal will fade upon direct exposure to light.

Recipes

2x Laemmli buffer (1 ml)
4% SDS
400 µl of 10% SDS
10% 2-mercaptoehtanol
100 µl
20% glycerol
200 µl
0.004% bromophenol blue
40 µl of saturated solution (0.1%)
0.125 M Tris HCl
125 µl of 1 M Tris HCl (pH 6.8)
Bring to 1 ml with water.
Nuclear Isolation buffer (1 L)
1 M Sorbitol
182.2 g
10 mM Tris-HCl (pH 7.5)
10 ml of 1 M Tris-HCl
10 mM EDTA
20 ml of 0.5 M EDTA
Autoclave, then add the following:
0.15 mM Spermine
52.2 mg
0.5 mM Spermidine
127 mg
Right before use, add:
2.5 mM PMSF
435 mg
Note: PMSF has a short half-life in aqueous solutions, 30-100 min.
Resuspension buffer 1 L 500 ml
1 M Sorbitol
182.2 g
91.1 g
10 mM Tris-HCl pH 7.5
10 ml of 1M Tris-HCl
5 ml
1 mM EDTA
2 ml of 0.5 M EDTA
1 ml
Autoclave, then add the following:
0.15 mM Spermine
52.2 mg
26.1 mg
0.5 mM Spermidine
127 mg
63.5 mg
Right before use, add (optional):
2.5 mM PMSF
435 mg
218 mg
ST buffer 100 ml
1 M Sorbitol
18.2 g
10 mM Tris-HCl (pH 7.5)
1 ml of 1 M Tris-HCl
Autoclave.
Add Protease Inhibitor Cocktail right before use at 10 μl per 1 ml.
TBS-T 1 L
NaCl
8 g
KCl
0.2 g
Tris base
3 g
Mix in ~ 800 ml dH₂O, adjust pH to 7.4 with HCl, then adjust volume to 1 L.
Autoclave
After cooling, add 1 ml Tween 20.
Western transfer buffer 1 L 9 L
Tris base
3.03 g
27.3 g
Glycine
14.4 g
129.6 g
Methanol
200 ml
1.8 L
Adjust volume to correct volume with dH₂O
Store at 4 °C for up to 1 month
Media Recipes
Glucose Minimal Medium (GMM)
20x sodium nitrate salts^*
50 ml/L
Trace elements (shake before using)
1 ml/L
D-glucose
10 g/L
Adjust pH to 6.5
Add ddH2O up to one liter
Autoclave 15 min, 121 °C
^*20x sodium nitrate salts solution
NaNO₃
120 g
KCl
10.4 g
MgSO₄.7H₂O
10.4 g
KH₂PO₄
30.4 g
Add ddH₂O up to 1 L
Autoclave and store at room temperature.
^**Trace elements
ZnSO₄•7H₂O
2.2 g
H₃BO₃
1.1 g
MnCl₂•4H₂O
0.5 g
FeSO₄•7H₂O
0.5 g
CoCl₂•5H₂O
0.16 g
CuSO₄•5H₂O
0.16 g
(NH₄)₆Mo₇O₂₄•4H₂O
0.11g
Na₄EDTA
5.0g
Add the solids in order to 80 ml of H₂O, dissolving each completely before adding the next. Heat the solution to boiling, cool to 60 °C. Adjust the pH to 6.5-6.8 with KOH pellets. Cool to room temperature and adjust volume to 100 ml with ddH₂O.

References

Palmer, J. M., Perrin, R. M., Dagenais, T. R. and Keller, N. P. (2008). H3K9 methylation regulates growth and development in Aspergillus fumigatus. Eukaryot Cell 7(12): 2052-2060.
Schagger, H. (2006). Tricine-SDS-PAGE. Nat Protoc 1(1): 16-22.
Soukup, A. A., Chiang, Y. M., Bok, J. W., Reyes-Dominguez, Y., Oakley, B. R., Wang, C. C., Strauss, J. and Keller, N. P. (2012). Overexpression of the Aspergillus nidulans histone 4 acetyltransferase EsaA increases activation of secondary metabolite production. Mol Microbiol 86(2): 314-330.